Fuel your savings with exclusive deals.
Rev up your inbox with weekly deals, clearance steals, and promo codes.
Online store run by Xpert Moto
Local pickup available for pre-orders only
On-site installation at our Lewisham workshop
Online store run by Xpert Moto
Local pickup available for pre-orders only
On-site installation at our Lewisham workshop
Online store run by Xpert Moto
Local pickup available for pre-orders only
On-site installation at our Lewisham workshop
Online store run by Xpert Moto
Local pickup available for pre-orders only
On-site installation at our Lewisham workshop
Call us at: 0433 880 748
Free shipping over $200 (excludes tyres and bulky items)
Need help? book@xpertmotogear.com.au
Explore related collections:
- ➔ Panels (1387 products)
- ➔ Side and rear body panels (808 products)
- ➔ Side panels (283 products)
Replacement side panels from UFO Plast for two-stroke Husqvarna CR models, finished in black. Sold under UFO part number 3304001, they are intended as a direct-fit replacement for damaged, faded or cracked original side panels.
Suited to riders restoring an older Husqvarna or refreshing a race bike between seasons, the panels reuse the existing mounting points so no modification is needed. Confirmed application is the Husqvarna CR 125, CR 250 and CR 360, 2000–2003.
- Direct replacement side panels for Husqvarna CR two-strokes
- Confirmed fitment: Husqvarna CR 125, CR 250 and CR 360, 2000-2003
- Black colourway
- Mounts to the original factory fixing points
- UFO Plast part number 3304001
| Brand | UFO Plast |
|---|---|
| Part Number | 3304001 |
| Type | Replacement side panels |
| Colour | Black |
| Fitment | Husqvarna CR 125 2000-2003; Husqvarna CR 250 2000-2003; Husqvarna CR 360 2000-2003 |
| Barcode (EAN) | 8052135018704 |
- Fit to the original factory mounting points; do not drill or modify the frame or subframe to suit.
- Refit the original grommets, washers and collars where the bike used them, so the panel is not clamped directly against bare metal.
- Do not over-tighten the fasteners; plastic panels can crack or distort around the mounting holes if pulled up too hard.
- Check panel fasteners after the first ride and periodically thereafter, as vibration can loosen them.
- Wash with warm water and a mild detergent using a soft cloth or sponge.
- Avoid petrol, brake cleaner, harsh solvents and abrasive pads, which can dull or craze the plastic surface.
- Keep high-pressure washer nozzles well back from the panel edges and mounting points.
- Clean and dry the panel thoroughly before applying graphics or decals, and work out air bubbles from the centre outward.
- Store spare panels flat and out of direct sunlight to avoid warping and UV fading.
- Choosing a selection results in a full page refresh.