Fuel your savings with exclusive deals.
Rev up your inbox with weekly deals, clearance steals, and promo codes.
Online store run by Xpert Moto
Local pickup available for pre-orders only
On-site installation at our Lewisham workshop
Online store run by Xpert Moto
Local pickup available for pre-orders only
On-site installation at our Lewisham workshop
Online store run by Xpert Moto
Local pickup available for pre-orders only
On-site installation at our Lewisham workshop
Online store run by Xpert Moto
Local pickup available for pre-orders only
On-site installation at our Lewisham workshop
Call us at: 0433 880 748
Free shipping over $200 (excludes tyres and bulky items)
Need help? book@xpertmotogear.com.au
Explore related collections:
- ➔ Oxford (997 products)
The Oxford Hot Grips V8i 9-Stage Heat Controller Replacement Switch is a genuine Oxford spare part for riders who need to restore the control unit on their existing V8i heated grip system. Rather than replacing an entire grip set, this switch provides a direct-fit solution to get your heated grips functioning again.
With nine selectable heat stages, it gives you the same precise warmth adjustment as the original controller, making it the sensible choice for maintaining a V8i-equipped setup through another season.
- Genuine Oxford replacement switch for Hot Grips V8i controller systems
- 9 selectable heat stages for precise hand-warmth adjustment
- Direct-fit replacement compatible with existing V8i wiring harness
- Cost-effective way to restore a V8i heated grip system without replacing the full kit
| Brand | Oxford |
|---|---|
| Model | Hot Grips V8i Replacement Switch |
| Type | Replacement heat controller switch |
| Heat stages | 9 |
| SKU | OXOFV8I |
| Barcode (EAN) | 5030009097492 |
- Disconnect the motorcycle's battery before beginning installation to prevent short circuits.
- Ensure the replacement switch connector is fully seated and locked into the existing V8i wiring harness before reassembling.
- Route and secure all cables with suitable ties, keeping them clear of hot surfaces, exhaust components, and moving parts such as the steering head.
- Do not pressure-wash the switch unit directly; wipe clean with a damp cloth only to avoid moisture ingress into the connector.
- Periodically inspect the wiring connector for corrosion or cracking, particularly after extended wet-weather or winter use.
- If corrosion is present on connector pins, use an appropriate electrical contact cleaner and allow to dry fully before reconnecting.
- Refer to the Oxford Hot Grips V8i installation documentation for wiring diagrams specific to your grip model before fitting.
- Choosing a selection results in a full page refresh.