Fuel your savings with exclusive deals.
Rev up your inbox with weekly deals, clearance steals, and promo codes.
Online store run by Xpert Moto
Local pickup available for pre-orders only
On-site installation at our Lewisham workshop
Online store run by Xpert Moto
Local pickup available for pre-orders only
On-site installation at our Lewisham workshop
Online store run by Xpert Moto
Local pickup available for pre-orders only
On-site installation at our Lewisham workshop
Online store run by Xpert Moto
Local pickup available for pre-orders only
On-site installation at our Lewisham workshop
Call us at: 0433 880 748
Free shipping over $200 (excludes tyres and bulky items)
Need help? book@xpertmotogear.com.au
Explore related collections:
- ➔ MTX Parts (1226 products)
A direct replacement speedometer cable from MTX Parts, made to suit the electric-start Yamaha AG200. It's built to meet or exceed the original equipment cable specification, so it fits and functions like the part it replaces.
Speedo cables live a hard life on ag and trail bikes — dust, mud, water and constant vibration all take their toll, and a frayed inner or split outer usually shows up as a jumpy needle or a dead speedo. This cable uses a black vinyl outer housing with a nylon inner sleeve, which keeps the action smooth and helps the cable last.
Suited to owners and workshops replacing a worn, kinked or seized factory cable on an AG200 electric start.
- Engineered to meet or exceed OEM cable specifications
- Suits Yamaha AG200 electric start models
- Black vinyl outer housing protects the cable
- Nylon inner sleeve for smooth operation and long service life
- Direct replacement for worn or degraded factory speedo cables
- Part of the wider MTX cable range covering throttle, brake, clutch and speedo applications
- Speedo cable
| Brand | MTX Parts |
|---|---|
| Part Number | MTXC07059 |
| Barcode | 9420060989137 |
| Type | Speedometer (speedo) cable |
| Fitment | Yamaha AG200 - electric start |
| Outer Housing | Black vinyl |
| Inner Sleeve | Nylon |
| Specification | Meets or exceeds OEM cable specifications |
| Sold As | Single cable |
- Check the fitment against your bike's model and start type before installation — this cable is specified for the electric-start AG200.
- Route the new cable along the same path as the original, keeping it clear of the exhaust, steering stops and any pinch points, and allow enough slack for full lock-to-lock steering and suspension travel.
- Hand-tighten the knurled collars at the speedo head and the front wheel drive unit; over-tightening can strip the threads or crush the outer housing.
- Make sure the inner cable is fully seated and engaged in the wheel drive gearbox before tightening — a partially engaged inner is a common cause of a dead or erratic speedo.
- Apply a light cable lubricant to the inner where the manufacturer of your bike recommends it, and grease the drive-unit end fitting sparingly so grease can't migrate up the cable.
- Inspect periodically for kinks, splits in the vinyl housing or fraying at the ends, especially after riding in mud, dust or water; replace the cable rather than trying to repair a damaged section.
- After washing or wet, muddy rides, let the cable drain and dry to reduce the chance of water sitting inside the housing and causing corrosion or binding.
- Avoid sharp bends or tight radii during installation and storage, as a kinked outer will cause the inner to bind and can shear the drive.
- Store spare cables coiled loosely in a cool, dry place, away from fuels and solvents that can attack the vinyl housing.
- Choosing a selection results in a full page refresh.