Trail Tech Voyager Pro Mounting Dock Kit

The Trail Tech Voyager Pro Mounting Dock Kit replaces the standard plastic dock on your Voyager Pro GPS with a dock machined from billet aluminium. It keeps the same hard-mount, quick-release convenience — the unit stays locked down while you ride and lifts out in seconds when you park up.

It's built for riders who spend their time where vibration, mud and water punish equipment: dirt bikes, dual-sport bikes, ATVs, UTVs, snowmobiles, snow bikes and overland vehicles. The aluminium body resists the housing flex and vibration that shortens the life of a standard dock, while water routing fences, upgraded pins and a pin seal help keep moisture out of the connection.

Vehicle sensors plug into waterproof JST connectors at the rear, and the Group Ride Buddy Tracking antenna screws into its own port, so every function of the Voyager Pro carries across to the upgraded dock.

• Machined from billet aluminium as a direct upgrade to the standard Voyager Pro dock
• Top thumbscrew provides a positive lock and holds the Voyager Pro at your chosen viewing angle
• Aluminium construction reduces the effects of vehicle vibration and housing flex
• Water routing fences divert water away from the dock
• Mechanically improved pins and pin seal for longer service life
• Waterproof JST connectors at the rear for vehicle sensor inputs
• Threaded rear port for the Group Ride Buddy Tracking antenna
• Hard mount with quick removal of the Voyager Pro GPS unit
• Compatible with Trail Tech mounting hardware, RAM mounts and custom brackets using the AMPs hole pattern
• Suits dirt bikes, dual-sport bikes, ATVs, UTVs, snowmobiles, snow bikes and overland vehicles

Mount the dock to Trail Tech hardware, a RAM mount or a custom bracket using the AMPs hole pattern, and check the mounting fasteners are secure before riding.
Seat the Voyager Pro fully into the dock and tighten the top thumbscrew by hand until the unit is held firmly at your preferred viewing angle — avoid over-tightening.
Re-check the thumbscrew and mounting fasteners after rough rides, as sustained vibration can loosen hardware.
Push the JST sensor connectors fully home so the waterproof seals engage; leave unused connectors capped or protected.
Screw the Group Ride Buddy Tracking antenna into the rear port finger-tight and keep the threads clean.
After muddy or wet rides, remove the Voyager Pro and rinse or wipe out the dock so mud does not build up in the water routing fences.
Clean with a soft damp cloth and mild detergent; avoid solvents and do not aim a pressure washer at the dock, pins or connectors.
Inspect the contact pins and pin seal periodically for dirt, corrosion or damage, and clear any debris before refitting the unit.
When the GPS is removed for storage, keep the dock covered or the bike under shelter to limit moisture sitting on the contacts.