LS2 OF616 Airflow II - White 06

The perfect helmet for urban riders. Very light and safe thanks to its HPTT shell. Modern design with two large air inlets that provide excellent ventilation. Wide visor with anti-scratch treatment.

SPECIFICATIONS

• Material: HPTT
• 1200 (±50 gr.)
• Sizes (1 Shell): XS - 3XL

SAFETY

• Micrometric Buckle
• Multi-Density EPS
• Reinforced Chin Strap
• Neck Roll

VENTILATION

• Top Vents
• Exhaust Port
• Channelled EPS
• Breath Deflector

COMFORT

• Ready for LS2 INTERCOM
• Removable and washable
• Breathable
• Hypoallergenic
• Laser-cut foam
• Neck Roll

VISOR

• Scratch-resistant
• UV-resistant
• Quick Release System

INTERCOM COMPATIBILITY

• Compatible with the LS2 Spectrum intercom

• HPTT thermoplastic shell for low weight
• Approximately 1200 g (±50 g)
• Single shell size covering XS to 3XL
• Two large front air inlets with rear exhaust port
• Channelled EPS for through-flow ventilation
• Multi-density EPS liner
• Micrometric ratchet buckle
• Reinforced chin strap
• Neck roll for reduced wind noise and improved comfort
• Breath deflector
• Wide visor with scratch-resistant and UV-resistant treatment
• Quick release visor system for tool-free changes
• Removable and washable interior liner
• Breathable, hypoallergenic laser-cut comfort foam
• Ready for the LS2 Spectrum intercom

Check the fit before first ride: the helmet should sit snugly with no pressure points, and the micrometric buckle should be adjusted so the chin strap is firm against the jaw and cannot be pulled off the head.
Remove the interior liner and cheek pads for washing; hand wash in lukewarm water with a mild soap, rinse thoroughly and air dry away from direct heat and sunlight before refitting.
Clean the shell with a soft cloth and warm water with a little mild soap only; avoid petrol, solvents, ammonia-based cleaners or abrasive products, which can damage the thermoplastic shell and its finish.
Clean the visor separately with warm water and a soft cloth. Never rub a dry visor and never use solvents or glass cleaner - the scratch-resistant and UV coatings can be stripped.
Soften dried insects or road grime by laying a damp cloth over the visor for a minute or two, then wipe gently rather than scrubbing.
Use the quick release system to remove and refit the visor without tools, and check the visor mechanism is fully engaged and rotates smoothly before riding.
Keep the front air inlets and rear exhaust port clear of dirt and insects so ventilation continues to flow through the channelled EPS.
Store the helmet in a cool, dry place out of direct sunlight, and keep it away from fuel and exhaust fumes - vapours can degrade the shell and liner over time.
Do not paint the shell or apply stickers and adhesives, and do not drill or modify the helmet in any way.
Replace the helmet after any significant impact or drop, even if no damage is visible, as the EPS may be compressed internally.
If fitting an LS2 Spectrum intercom, use the provided intercom recesses and route wiring so it does not sit between the EPS and your head.