Leatt 3.0 Knee & Shin Guard Extension- Black

FULL-LENGTH HARD SHELL EASY FIT IMPACT FOAM PROTECTOR.

This hard-shell knee and shin guard has an extended-length design with 3DF impact foam that offers premium CE-tested and certified protection.

There is no sock or sleeve, instead, the guard is fitted using a strap system that can be worn under or over the pants, featuring a slim knee pad profile and improved sliding surface the 3.0 EXT fits comfortably being handed left and right.

Features:

• Hard shell and 3DF ventilated impact foam.
• 3D design for optimal fit with specific left and right sides.
• Slim shin plate that also fits inside boots.
• CE tested and certified as impact protection: Knee and shin EN1621-1
• Full shin extended length – EXT
• Improved hard shell sliding surface.
• Weight: From 600g (1.32lbs) pair
• Plastic-free recyclable packaging

• Full-length extended shin coverage (EXT) hard-shell design
• 3DF ventilated impact foam liner behind the hard shell
• CE tested and certified as impact protection to EN 1621-1 (knee and shin)
• No sock or sleeve — strap fitting system, wearable under or over pants
• 3D shaped with handed left and right sides for a closer fit
• Slim knee pad profile and slim shin plate that also fits inside boots
• Improved hard-shell sliding surface
• From 600 g per pair
• Plastic-free recyclable packaging

• Pair of knee and shin guards (left and right)

Check the left and right markings before fitting — the guards are handed and will not sit correctly if swapped.
Position the hard shell centred over the kneecap with the shin plate running straight down the front of the leg, then tension the straps snugly enough to stop movement without cutting circulation.
The slim shin plate is designed to sit inside most boots; slide it in before doing up the boot buckles so the plate sits flat against the shin.
Re-check strap tension after the first few minutes of riding, as straps commonly settle once you are moving.
Hand wash with lukewarm water and mild soap, then rinse thoroughly — avoid solvents, petrol, brake cleaner and abrasive scourers, which can damage the shell and degrade the impact foam.
Air dry completely at room temperature, out of direct sunlight, and never use a heat gun, dryer or radiator; heat can distort the shell and harden the foam.
Store flat or hanging in a cool, dry place away from prolonged sunlight and fuel or chemical fumes.
Inspect the straps, buckles and shell before each ride, and replace the guards if the shell is cracked or deeply gouged, the foam is torn or permanently compressed, or the strap system no longer holds tension.
After a heavy crash, treat the guards as suspect even if damage is not obvious — impact protectors are designed to absorb energy once.