Leatt 2.0 Junior Fusion Vest - Black

The Leatt Fusion Vest 2.0 Junior brings neck, chest, back, flank and shoulder protection together in a single piece of body armour built specifically for young off-road riders. Rather than layering a separate neck brace over a chest protector, the Fusion integrates a neck brace structure into the vest itself, so there is one item to fit, adjust and put on before a ride.

Protection comes from 3DF AirFit soft impact foam, which stays flexible and ventilated while riding but stiffens instantly on impact to help absorb crash forces. The three-dimensional, junior-specific shaping keeps the armour close to the body, and the neck brace structure is moulded in fibreglass-reinforced polyamide resin with an engineered fracture point on the rear thoracic strut, designed to snap off in an emergency.

Suited to junior motocross, enduro and trail riders and to parents who want CE-certified coverage in one easy-to-fit unit. Finished in black, with a number plate clip-in function and no-tool sizing adjustments.

• All-in-one neck, chest, back, flank and shoulder protection for junior riders
• 3DF AirFit ventilated soft impact foam that hardens instantly on impact
• Built-in neck brace structure in fibreglass-reinforced polyamide resin
• Engineered fracture point on the rear thoracic strut, designed to snap off in an emergency
• Collarbone cut-out to help protect fragile bones
• CE tested and certified as Personal Protective Equipment (89/686/EEC)
• Chest impact protection certified to prEN1621-3 Level 1
• Back impact protection certified to EN1621-2 Level 1
• Shoulder impact protection certified to EN1621-1, plus flank protection
• Number plate clip-in function
• Easy no-tool sizing adjustments
• Lightweight, flexible three-dimensional design from 1.35 kg in S/M

Size the vest to the rider's height (105-165 cm range) and set it up using the no-tool sizing adjustments before the first ride; re-check the fit as the rider grows.
Check the vest fits correctly with the rider's helmet on, so the neck brace structure sits clear of the helmet at normal riding head positions.
Clean the shell and 3DF AirFit foam with lukewarm water and a mild soap, then air dry away from direct sunlight and heat sources.
Do not use solvents, petrol, bleach or harsh chemicals on the foam or the polyamide neck brace structure, and do not tumble dry.
Rinse off mud and sweat after wet or dusty rides, and dry the vest fully before storing so the foam does not stay damp.
Store flat or hanging in a cool, dry place out of direct sunlight, and avoid leaving it compressed under other gear or in a hot vehicle.
Inspect the vest after every crash: the rear thoracic strut has an engineered fracture point designed to snap off in an emergency, so any broken, cracked or deformed component means the vest must be replaced.
Check straps, buckles and the number plate clip-in point regularly for wear, and retire any impact protection that is damaged, permanently compressed or no longer fits correctly.