Oneal 25 10SRS S/P-Helm Peak Elite V.22 BLK/WHT Adult

This is the genuine O'Neal replacement peak for the 10 Series (10SRS) Elite V.22 off-road helmet in the black/white colourway. It is sold as a single peak so you can refresh a scratched, cracked or roost-battered peak without replacing the whole helmet.

Suited to motocross, enduro and general off-road riders running the 10SRS Elite V.22, and a practical spare to keep in the gear bag or race trailer for race-day repairs.

Fits O'Neal 10SRS Elite V.22 helmets only. Please confirm your helmet model and colourway before ordering.

• Genuine O'Neal replacement peak for the 10 Series (10SRS) Elite V.22 helmet
• Black/white colourway to match the 10SRS Elite V.22 Black/White helmet
• Sold as a single peak (visor)
• Restores peak protection without the cost of a new helmet
• Part number ON0630220
• Intended for motocross, enduro and off-road use

• One replacement helmet peak

Check that the peak is the correct part for your helmet model and generation before fitting; peaks are not interchangeable between O'Neal helmet ranges.
Fit the peak using the helmet's original hardware, seating it evenly on both sides before tightening.
Tighten fasteners firmly but do not overtighten — plastic mounting points can strip or crack.
Re-check the fasteners before each ride, as vibration and roost impacts can loosen them over time.
Clean with lukewarm water, mild soap and a soft cloth; wipe mud off gently rather than scrubbing when dry.
Avoid petrol, solvents, degreasers, harsh cleaners and abrasive pads, which can dull or craze the finish.
Do not leave the peak in direct sun, on a hot exhaust or near heaters, as heat can distort the plastic.
Replace the peak if it is cracked, deeply gouged or has been through a heavy crash — a damaged peak can break away or interfere with airflow.
Store spares flat and unweighted in a cool, dry place to prevent warping.