Motion Pro - Sherco 125/250/300 SE 2T Throttle Cable (10-0178)

The Motion Pro throttle cable (part number 10-0178) is a direct-fit replacement for Sherco 125, 250 and 300 SE two-stroke off-road bikes. Motion Pro specialises in precision-manufactured cables and controls for powersports, and this cable is engineered to match OEM routing and pull length for a straightforward swap.

Suited to trail riders, enduro competitors and mechanics looking for a reliable aftermarket replacement that installs without modification.

• Direct OEM-style fitment for Sherco 125/250/300 SE 2T models
• Motion Pro part number 10-0178
• Designed as a drop-in replacement — no modification required

Before installation, route the new cable to match the original OEM path, ensuring no sharp bends or kinks.
Lubricate the cable inner wire with a cable lubricant prior to fitting, and re-lubricate periodically — especially after riding in wet or muddy conditions.
After fitting, adjust freeplay at the throttle housing to manufacturer specification; there should be a small amount of slack with the bars turned to full lock in both directions.
Check that the throttle snaps shut instantly when released from full open — with bars at straight ahead, full left and full right lock.
Inspect the cable for fraying, kinking or corrosion at each service interval and replace if any damage is found.
Do not allow the cable to contact hot exhaust components; use original cable guides and clamps to maintain correct routing.
Store the cable in a dry location if held as a spare; avoid coiling tightly, as this can cause permanent kinks.