HJC V10 Helmet - S.F BLACK

The HJC V10 is a full-face road helmet built around HJC's PIM (Premium Integrated Matrix) polycarbonate shell, offering a practical balance of structural rigidity and everyday wearability for commuters and weekend riders.

The semi-flat black finish delivers a clean, low-gloss look that suits a wide range of bikes without drawing attention to itself. Inside, a removable and washable SilverCool antibacterial liner keeps the helmet fresh across repeated use.

A RapidFire tool-free shield replacement system and Pinlock-ready visor make the V10 straightforward to live with in variable Australian riding conditions.

• Full-face design for comprehensive head and face coverage
• PIM (Premium Integrated Matrix) polycarbonate shell
• ECE 22.06 certified
• RapidFire tool-free shield replacement system
• Pinlock-ready visor to reduce fogging
• Removable and washable SilverCool antibacterial interior liner
• Multi-position ventilation with intake and exhaust vents
• Semi-flat (satin) black finish

Clean the outer shell with a soft damp cloth and mild soap; never use solvents, petroleum-based products, or abrasive materials as they degrade the polycarbonate shell and finish.
Clean the visor with a mild solution and a soft cloth only; ammonia-based or abrasive cleaners will permanently haze the lens surface.
Remove the interior liner and cheek pads before washing; hand-wash in cool water with mild detergent or machine-wash on a gentle cold cycle, then air-dry away from direct heat sources.
Fit the Pinlock insert to the inner visor pins when riding in cold or humid conditions to minimise fogging; ensure the seal around the insert's perimeter is intact before each use.
Store the helmet in a cool, dry location out of direct sunlight; prolonged UV exposure and heat degrade both the shell and the EPS liner.
Keep the helmet away from fuel, chain lube, solvents, and other chemicals — contact with these substances can compromise structural integrity even without visible damage.
Replace the helmet after any significant impact regardless of visible damage; the EPS liner is a single-use energy-absorbing component.
Inspect the visor regularly for chips or deep scratches that distort vision; replace the shield if clarity is affected.
Check that vent sliders open and close freely and that the RapidFire visor release clicks positively into each position; apply a small amount of silicone-based lubricant to pivot points only if movement becomes stiff.
As a general guideline, retire and replace the helmet five years from its date of manufacture, as shell and liner materials age regardless of use.