HJC i100 Helmet - BEIS MC-3HSF

The HJC i100 is an open-face three-quarter helmet built for everyday riders who want the freedom and peripheral visibility of an open shell without sacrificing convenience. The integrated drop-down internal sun visor is the i100's defining feature, removing the need to carry or swap a separate tinted shield.

The Beis graphic in MC-3HSF high-visibility colourway gives this helmet a bold, distinctive look suited to commuting and leisure riding alike. A lightweight polycarbonate shell, removable washable liner, and SilverCool antibacterial interior fabric make it a practical daily-use choice across a range of climates.

• Open-face (3/4 shell) design for wide peripheral vision and natural airflow
• Integrated drop-down internal sun visor for on-the-fly glare management
• Lightweight polycarbonate composite shell
• SilverCool antibacterial interior fabric
• Removable and washable cheek pads and interior liner
• Beis graphic in high-visibility MC-3HSF colourway
• Available in XS, S, M, L and XL

Clean the outer shell with a soft cloth dampened with mild soap and warm water; avoid petroleum-based solvents, petrol, brake fluid, or paint thinners as these degrade the polycarbonate shell and graphics.
Clean the drop-down sun visor and face opening area with mild soap and water only; never use ammonia-based or abrasive cleaners, which cause micro-crazing on optical surfaces.
Remove the cheek pads and interior liner for periodic washing — hand-wash in cool water with a mild detergent and allow to air-dry completely before re-fitting.
Store the helmet in a helmet bag or padded case on a stable flat surface, away from direct sunlight, extreme heat, and fuel or solvent vapours, which degrade EPS and shell materials over time.
Replace the helmet immediately following any significant impact, even if no external damage is visible — the EPS liner absorbs energy through permanent deformation and will not protect effectively a second time.
Inspect the drop-down sun visor mechanism and retention/ratchet system before each use; if the mechanism becomes stiff or does not seat fully, clean the pivot points with a dry cloth and do not force it.
Check the chin strap, fastener, and D-ring or micro-lock buckle for wear or damage before every ride, and replace the strap if any fraying or deformation is found.
Do not apply adhesive stickers, paint, or chemical-based products directly to the shell surface, as these can compromise the structural integrity of the polycarbonate.