Giant Loop Mounts (2 Pack)

The Giant Loop Strap Anchors are heavy-gauge stainless steel quick mounts that bolt directly to your bike, giving Giant Loop saddlebags, panniers, dry bags and tank bags a fixed, purpose-built anchor point instead of an improvised one. Supplied as a 2 pack.

Because the anchor sits where you bolt it, straps run shorter and tighter — which means less load shift over rough ground — and can be routed clear of hot exhaust headers. Fitting and removing luggage becomes a much quicker job once the anchors are in place.

Built for adventure and dual-sport riders running soft luggage, the anchors are equally at home on snowmobiles, snow bikes, ATVs, UTVs, side-by-sides, 4x4s and boats — anywhere you need a solid tie-down point for 1-inch webbing.

• Heavy-gauge stainless steel construction
• Bolts directly to the vehicle for a fixed, repeatable anchor point
• Keeps luggage straps clear of hot exhaust headers
• Shortens strap runs for a more stable, less shifty load
• Speeds up fitting and removal of Giant Loop saddlebags, panniers, dry bags and tank bags
• Slot width 1-1/8 inch, sized for 1-inch webbing
• 10 mm mounting hole
• Compact 1.75 inch wide x 2.5 inch long footprint
• Suits motorcycles, snowmobiles, snow bikes, ATVs, UTVs, side-by-sides, 4x4s and boats
• Supplied as a 2 pack

• 2 x Giant Loop strap anchors

Choose a mounting point that takes a 10 mm bolt and sits on solid, load-bearing structure — not bodywork or plastic panels.
Use the vehicle manufacturer's specified bolt and torque figure for whichever fastener you relocate or reuse; do not overtighten.
Position the anchor so webbing runs clear of the exhaust headers, tyre, chain, suspension travel and any moving controls.
Thread only 1-inch webbing through the slot — wider straps will not seat correctly.
Check bolt tightness and strap condition before each ride, and again after the first hour of rough or corrugated riding while everything settles.
Inspect the webbing where it passes through the slot for chafing or heat damage, and replace any strap showing wear.
Rinse with fresh water and dry after riding in mud, salt spray or on beaches — stainless steel resists corrosion but the surrounding fasteners may not.
Do not fit to 2017-2021 KTM or Husqvarna 250-500cc models; the available bolt location can tear straps and rub against riding boots.
Remove the anchors and refit the original hardware if you sell or return the bike to standard.