GIVI Bolt Kit for E251/Z113C Universal Base Plates

The Givi Z410 is the mounting bolt kit for Givi's E251 and Z113C universal base plates. It supplies the fixing hardware needed to secure the base plate, sold as a genuine Givi service part under catalogue reference Z410.

It's the part to order if you've bought a base plate second-hand, misplaced the original fixings during a rack swap, or found the existing bolts corroded or damaged. Rather than replacing a perfectly good plate, you replace only the hardware.

Please check your base plate against the E251 / Z113C references before ordering, as Givi hardware is not interchangeable between plate types.

• Genuine Givi service part, catalogue reference Z410
• Mounting hardware for Givi E251 and Z113C universal base plates
• Replaces fixings lost, corroded or damaged during a rack change
• Restores a used or second-hand base plate without buying a complete plate

Fit using the instruction sheet supplied with your base plate or luggage rack, following the bolt positions shown for that plate.
Tighten the fixings evenly and progressively in a cross pattern rather than fully tightening one at a time.
Do not overtighten — excessive force can distort the plate or strip the thread.
Re-check tightness after the first ride with a loaded case, then periodically as part of routine maintenance.
Do not substitute bolts of a different length, thread or grade; incorrect hardware can foul the rack or fail under load.
Remove the top case and any load before loosening or removing the fixings.
Rinse away road salt and grit after wet-weather riding and dry the hardware to limit corrosion.
Replace any fastener that shows corrosion, thread damage or rounding rather than refitting it.