Bell S/P - Moto-10 Peak M/Piece Kit Fasthouse MOD SQD M/G WHT/BLK

A genuine Bell replacement peak and mouthpiece kit for the Moto-10 Spherical helmet, finished in the Fasthouse Mod Squad matte and gloss white/black graphic so it matches the helmet it was made for.

Peaks and mouthpieces take the brunt of roost, branches and the odd tip-over, and they are the parts most likely to get scuffed or cracked long before the helmet itself is due for retirement. This kit lets you refresh both in one go, or keep a spare set in the gear bag for race weekends.

Replacement parts only — helmet not included.

• Genuine Bell replacement part, not aftermarket
• Peak (visor) and mouthpiece supplied together as a single kit
• Made specifically for the Bell Moto-10 Spherical helmet
• Fasthouse Mod Squad graphic in matte/gloss white and black to match the helmet
• Refresh damaged or scuffed parts without replacing the whole helmet

• Moto-10 Spherical helmet peak (visor)
• Moto-10 Spherical mouthpiece

Fits the Bell Moto-10 Spherical only — check your helmet model before ordering or fitting.
Fit the peak using the helmet's original hardware and follow the fitting instructions supplied with your helmet.
Tighten the peak fasteners by hand only; over-tightening can strip the threads or crack the peak.
Check the peak and mouthpiece fasteners are secure before each ride, particularly after transport in a gear bag.
Clean with warm water and a mild soap using a soft cloth, then rinse and allow to air dry.
Avoid solvents, petrol-based cleaners and abrasive pads — they can dull the matte finish and weaken the plastic.
Do not dry the parts near a heater or leave them on a dashboard; heat can distort the plastic and lift the graphics.
Replace the peak or mouthpiece if it is cracked, distorted or has taken an impact, rather than attempting a repair.
Store the helmet and any spare parts in a padded bag out of direct sunlight and away from fuel or chemical fumes.